Cisco Linksys PAP2 VOIP Gateway Configuration And Setup Guide

1- Features of the Cisco Linksys PAP2:

-The PAP2 offers the benefits of high-quality voice over IP (VoIP) without the need to upgrade your existing analog phones. The ability to connect standard  (analog) telephones and fax machines to VOIP  networks  

-encryption for data transmissions

-password-protected and administrative options

-Compatibility with  telephone features such as caller ID, call waiting .....

-use the two standard telephone ports to connect your  phones or fax machines. Each phone port operates independently that serve as separate lines

2-Initial Setup

- Connect your analog Phone cable into the "PHONE 1" Port of the Phone Adapter (Linksys pap2)

-If you have a second Vonage line , then connect another Phone Cable  to the "PHONE 2" port of  Linksys pap2(ATA Device)

-Plug the Ethernet cable into the Ethernet port of the Linksys PAP2 (ATA Device).

-Connect the power cord to the Linksys PAP2 (ATA Device).

3- Linksys PAP2 Configuration
 3-1-Connect an analogue phone to the Linksys "phone1" port
 3-2-Using the analogue phone:
    press "****" and after the greeting message press 110#  , You will now hear a message giving you the IP address of of the adapter such as  "192.168.1.100".
3-3 From the internet browser address window, type in the IP address

3-4 -Click on the “Admin Log In” link in the upper right corner of the

Linksys page.Click on the "Switch to Advanced View"

3-5 Click the System tab, and in the Internet Connection Type section, click the

DHCP drop-down menu, and select yes or no.If you set DHCP to no, enter the Static IP, NetMask, and Gateway information

3-6 On the Advanced View click on the SIP tab.

Under the NAT Support Parameters heading you will need to enable STUN and enter one ofthe two STUN server addresses 

NAT Support Parameters 

Stun enable : yes

Stun server:Adress Stun server

3-7 Click on the LINE 1 tab AND enter below infomations provide by us.

SIP Settings 

LINE ENABLE: Yes

SIP PORT: 5060

Proxy And Registration

PROXY: Adresse Proxy

OUTBOUND PROXY: Adresse Proxy

MAKE CALL WITHOUT REG: No

ANS CALL WITHOUT REG: Yes

USE DNS SRV: Yes

DNS SRV AUTO PREFIX: Yes

Subscriber Information

DISPLAY NAME: Enter your  VoIP Number

USER ID: Enter your  VoIP Number

PASSWORD: Enter your  VoIP Password

NAT Settings

NAT MAPPING ENABLE: Yes

NAT KEEP ALIVE: Yes

Audio Configuration

PREFERRED CODEC: G.729a

3-8 click on the “Submit All Changes” button (located at the bottom of each page) and the router will save all the changes and reboot,

Related post