MeetMe Conferencing Cisco VOIP Phone Command

An ad hoc conference can be started with an analog hook flash, or using the Conf softkey on a
Cisco VOIP phone.
In a MeetMe conference, the controller starts the conference at a specified number, and users dial
into that number.
1) Set up a range of conference numbers in CallManager.
2) Conference controller goes offhook on a Cisco VOIP phone, hits More... softkey, then selects
MeetMe softkey.
3) Controller dials a MeetMe number in the specified range.
4) Other users then dial the MeetMe number directly. They should not use the MeetMe softkey.
Note that users can be located anywhere but that the controller must be on a VOIP phone registered with the CallManager hosting the MeetMe number range.
Read More:http://iiusatech.com/VOIPCommandRef.pdf

Related post



Newer Post Older Post

0 comments:

Post a Comment

 

Wiki Voip And Fax Tutorials Copyright © 2010 Labloub